Description

The next generation of foldable license plate holders — engineered to stay put. Most foldable plate holders loosen up over time. V3 doesn't. A spring-loaded mechanism holds constant tension on the plate, so it stays firmly in position even through hard riding, rough terrain, and constant vibration — no more rattling, sagging, or re-tightening every few weeks. Key Features Spring-Loaded Fold Mechanism Fold the plate down and it locks in place with a splint. Pull the splint, and the spring snaps the plate back into riding position instantly — no manual adjustment needed, no loosening over time. Quick-Release Snap-In System A second, independent splint lets you remove the entire license plate assembly in seconds. Perfect for photos, track days, or simply cleaning up the look of your rear end when the plate isn't legally required. Full E-Marked Lighting (Integrated) LED tail light & brake light — E-marked LED license plate light — E-marked Both lights are built directly into the holder — fully road-legal lighting, no additional wiring or parts needed. Water Drainage Holes Unlike sealed designs where water pools and sits trapped, V3 includes drainage holes that let moisture escape — protecting your electronics and preventing corrosion. Adjustable Plate Angle 5 included spacers let you fine-tune the plate angle exactly to your preference — from tucked-in aggressive to fully visible. Optional Indicator Extension Swiss/EU regulations require 18 cm of distance between indicators. Since not everyone likes the look of an extension, it's offered as an optional add-on rather than built in — so you decide between full compliance and a cleaner silhouette. An 8 mm mounting hole is built into the holder for installing indicators. We recommend using RevSticks LED indicators for the best fit and finish. Direct Fit — No Drilling Required This version includes a mounting adapter designed to fit your bike's original mounting holes. No drilling, no countersunk screws, no M6 nuts — just 2 screws (included) that thread directly into your rear fender's original plastic mounting points. What's Included License plate holder (Large or Small) — with integrated E-marked LED tail/brake light, E-marked LED plate light, fold splint, and snap-in splint Mounting adapter for direct fit to original mounting holes 2× screws (fit original rear fender mounting points) 5× angle-adjustment spacers Connector type: Mini Japanese Plug (male/female) ⚠️ Note: The included connectors likely won't match your bike's original wiring plugs. You'll need to solder the connections directly, or — for a cleaner, tool-free installation — use matching connectors from our accessories range, available in our shop. Installation Requirements No drilling required Standard screwdriver / hex key (depending on screw type) Thread lock, e.g. Loctite (recommended) ⚠️ Note: This version is designed for direct fit to your bike's original mounting points — no modification to the rear fender is required. ⚠️ Legal Notice The fold-down (splint-in) position is intended for off-road/track use or storage only and is not permitted for use on public roads. When riding on public roads, the license plate must always be folded out and secured in the visible, upright riding position, with the plate clearly legible and correctly illuminated at all times. Riding with the plate folded in on public roads may violate local road traffic regulations and can result in fines. The buyer is solely responsible for using this product in compliance with the road traffic laws of their country. RevSticks accepts no liability for fines or penalties resulting from improper or illegal use.